Installation
Page 10
2. Mount the one end of the universal joint shaft on the tractor.
3. Mount the other end of the universal joint shaft on the implement.
4. In the shortest work position, mark the piece that will be sawn off on one half of the
universal joint shaft.
Fig. 2: Mark the cutting point
Fig. 3: Sawing the universal joint shaft to
length
5. Cut off the universal joint shaft guard to the marking.
6. Saw off the profile tube. Attention: The profile tube must be 10 mm longer than the guard.
Fig. 4: Sawing off the profile tube
Fig. 5: Deburring of the cut edges
7. Repeat steps described steps on the other half of the universal joint shaft.
8. Deburr the sawn edges.
9. Grease the profile tube.
Fig. 6: Greasing the profile tubes
10. Slide the profile tubes together.
4.3.2
Mounting the universal joint shaft
