INFORMATION
6
May 2006
/ WHISPER 3,5 / EN
power should never exceed 3 kW. Power is rated at
an ambient temperature of 40°C and a seawater
temperature of 25ºC. For higher temperatures the
generating set has to be derated.
3
VOLTAGE shows the nominal voltage.
This voltage should be within the specified tolerance
at the nominal frequency.
4
FREQUENCY is shown in Hz and is determined by
the speed of the engine (RPM). 50 Hz correlates with
3000 rpm, 60 Hz correlates with 3600 rpm.
5 CURRENT shows the maximum current that is
acceptable at the specified frequency, voltage and
power factor.
6
WEIGHT shows the net dry weight (approximately) in
kg. This is without fuel, oil, packing and external
installation equipment
7
The CE symbol shows that the generating set is build
according to European Community safety regulations.
This includes the regulations regarding the safety of
pleasure craft, machinery, electric safety and electric
magnetic compatibility (EMC) and other relevant
directives.
Safety also relies on the installation, application and
circumstances. See also the remarks in this manual under
SAFETY
Before changing a factory setting you are advised to
consult the manufacturer. When the generating set you
have to identify is not new you have to take into account
the possibility that former users may have changed the
settings. Check the settings (voltage, frequency, rpm)
when there is any doubt.
2 INFORMATION
2.1 SAFETY
2.1.1 General
When correctly installed and used in normal
circumstances this generating set fulfils EC safety
regulations. This generating set could be part of an
installation or could be used in a way that additional
regulations of the EC or other authorities have to be taken
into account.
Circumstances could make it also necessary
to take additional measures. Be aware of wet
conditions and hazardous environments
caused by explosive gases etc
2.1.2
Electrical safety
The voltage of 230 Volt generated by this
generating set is dangerous and if instructions
and procedures are not strictly observed may
result in electrical shock which will result in
severe personal injury or loss of life.
•
Check all wiring at least once a year. Defects,
such as loose connections, burned cables etc.
must be repaired immediately.
•
Do not work on the electrical system if it is still
connected to a current source. Only allow
changes in your electrical system to be carried
out by qualified electricians.
•
Connection and protection must be done in
accordance with local standards.
•
Using the auto-start/stop (interval) mode the
generator can start unexpectedly. When working
on the electrical system, the 3 Amp fuse must be
removed from the control panel and the battery
plus cable must be removed from the battery.
Warning signs indicate parts which could be
live.
2.1.3
Earth insulation failures
According to local regulations and depending on the
application it could be necessary to take measures for
protection against earth insulation failures.
In the standard delivery “neutral” and “ground” are not
connected. To make a connection between “neutral” and
“ground” could be necessary as part of a specific
insulation failure protection system.