MasterCraft prostar 190 2011, Руководство пользователя

Страница: 66 / 139

2011 Owners Manual...Instrument Gauges and Switches...Page 5-8
The key will be in one of four (4) positions:
• Off
• Accessory (including running the stereo without the engine running)
• ON (engine is running)
• Start (turn the key to engage the engine starter, then release to allow the key to automatically return to
the ON position)
Never leave the ignition switch in the ON position without the engine running, as this will cause the bat-
tery to discharge.
Note: The MariStar 280STS is equipped with two (2) ignitions, one (1) for each engine, allowing the engines to oper-
ate independently of each other. Be sure to turn
both ignitions OFF when the engine is not in use.
Instrument Panel Gauge Backlighting Switch
(All models equipped with the Video Display Gauge System)
A three-position switch allows the operator to change the instrument panel backlighting for the gauges. Press-
ing the top of the switch will cause the lights to brighten, and pressing down will dim the lights.
Low Voltage Battery Alarm
(All Models)
In the event that the stereo has been functioning when the boat is not ON and running, the voltage drain
on the battery (or batteries) may result in difficulties with re-starting the boat. It may also cause intermittent
erroneous or fluctuating gauge readings. When the voltage level reaches 11.5 volts or below, the system will
shut off the stereo and sound the alarm for a period of two (2) minutes to give boaters sufficient time to ad-
just. Generally, the appropriate action is to leave the stereo OFF, as well as disengaging any other peripheral
electrical components, and keying ON the engine. Running the engine at a moderate rate for several minutes
without the additional drain of stereo and unnecessary electrical equipment will allow the alternator to re-
charge the battery or batteries, unless the battery(ies) have been used to the extent of their life span.
Carbon monoxide is emitted from the engine’s exhaust system. Never run the engine without
proper ventilation. Do not run the engine in a confined space or where fumes may be trapped.
Do not run the engine when the boat is stationary in calm wind conditions.
Navigation/Anchor Lights Switch
(All Models)
A three-position switch serves to activate exterior lighting. Turning the switch in the up position will acti-
vate bow and stern lights, the middle position is OFF, and the down position is for stern-only lighting.
Other Alarms
(All Models)
Sensors check the oil pressure, engine and transmission temperatures. If the system detects readings
outside the acceptable range, the system shuts off the stereo and sounds the alarm for a period of one (1)
minute. This signals the need to return to shore as soon as possible and seek assistance from your authorized
MasterCraft dealer’s service department to diagnose and, if necessary, repair the problem.
Refrigerator Switch
(MariStar 280, X-80, CSX 265, X-65)
This switch will run the refrigerator when turned ON. The refrigerator runs off the boat’s electrical
and battery system. Therefore, care should be given to ensure that the battery is not drained to such an
extent that the voltmeter alarm sounds.