2011 Owners Manual...Troubleshooting...Page 20-1
Troubleshooting
The following chart will assist you in finding and correcting minor mechanical and electrical problems with
your MasterCraft boat. Engine manuals include troubleshooting suggestions regarding drive train issues.
To correct a problem, first determine what the symptom is. Start with the first cause and eliminate the pos-
sibility of each until the problem is corrected. Due to the specialized skill and tools needed to correct major
issues, that information has not been discussed below. If a problem is not addressed herein, please contact an
authorized MasterCraft dealer’s service department.
When experiencing a problem, check the surroundings before shutting down the boat. If a sudden stop
would place other boaters in jeopardy, continue on until it is safe to slow or stop to analyze the situation.
Always be aware of the surroundings and how actions may impact other boaters!
Throttle/shifting problems.
Corroded cables.
Clean and lubricate the cables.
Low transmission oil level.
Replenish transmission fluid.
Sticking transmission shift detent ball.
Clean and lubricate the detent ball.
Kink in cable(s).
Have authorized MasterCraft technician
replace the cable(s).
Steering problems.
Corroded cable.
Clean and lubricate the cable.
Rudder worn.
See authorized MasterCraft dealer’s
service department.
Excessive vibration.
Bent strut.
Replace the strut.
Fouled propeller.
Remove objects from the propeller shaft and rudder.
Damaged propeller.
Replace the propeller.
Misaligned propeller shaft coupling.
Seek proper alignment.
Bent propeller shaft.
See authorized MasterCraft dealer’s
service department.
Electrical problems.
Open circuit breaker or blown fuse.
Re-set the circuit breaker or replace the fuse.
Loose wiring connections or corrosion.
Clean and tighten wiring connections.
Defective sending unit.
Replace the sending unit.
Shorted wiring harness.
Have the wiring harness repaired.
Defective switch or gauge.
See authorized MasterCraft dealer’s
service department.
No speedometer reading.
Defective speedometer.
Have the speedometer checked or replaced.
Defective speedometer paddle wheel.
Have paddle wheel checked or replaced.
Incorrect speedometer reading.
Improper calibration.
Follow calibration instructions in
Instruments and Gauges
section
of this Manual.
Gauges do not work or the
Breaker has tripped.
Re-set the breaker.
accessory does not work.
Fuse has blown.
Replace the fuse.
Low battery.
Check the battery voltage for a loose ground.
Insufficient battery supply.
Replace battery with one that has at least 750CCAs.
Содержание prostar 190 2011
Страница 26: ...Guide to Individual Models 2011 Owners Manual Guide to Individual Models Page 4 1...
Страница 81: ......
Страница 93: ......
Страница 105: ......