Page 30
WARNING: Before performing any
repair work, always unplug the saw and
wait until the cutting blade has come to
a standstill.
CAUTION: Improper repairs can
result in the product functioning
unsafely. This endangers yourself and
your environment.
Faults which cannot be rectified with the
aid of following table may be rectified by
an authorized service center.
Please be aware that any improper repairs
will also invalidate the warranty and
additional costs may be incurred.
Use only manufacturer approved spare
parts. Only these spare parts are designed
and suitable for the product. The use of
other spare parts not only voids the
warranty, you can also endanger yourself
and your environment.
Fault/malfunction
Cause
Remedy
Motor does not power
on.
Brush worn.
Contact customer service center.
Brush sparks
excessively when
switch is released.
Brush worn/damaged.
Replace brushes.
See MAINTENANCE chapter
Blade hits table.
Misalignment
See ASSEMBLY chapter.
Angle of cut is
inaccurate.
Miter table is unlocked.
Use miter-lock knob.
See ASSEMBLY chapter.
Too much sawdust under
table.
Vacuum or blow out dust.
WEAR EYE PROTECTION!
Cutting arm cannot
fully raise or blade
guard cannot fully
close.
Parts failure.
Contact customer service center.
Pivot spring not replaced
properly after service.
Contact customer service center.
Sawdust buildup.
Clean and lubricate moving parts.
Blade binds, jams, or
burns wood.
Improper operation.
See ASSEMBLY chapter.
Dull blade.
Replace or sharpen blade.
Improper blade.
Replace blade.
Warped blade.
Replace blade.
Saw vibrates or
shakes.
Saw blade is damaged.
Replace blade.
Saw blade is loosened.
Tighten arbor bolt.
TROUBLESHOOTING
