Page 18
SETTING THE CUTTING DEPTH
WARNING Before performing any
assembly or adjustment, always
disconnect from power source. Failure
to unplug your saw could result in
accidental starting causing serious
injury.
WARNING To avoid risk of personal
injury, if movement is tight or if there is
play in the adjustment, have your saw
serviced by an authorized service
center before using or contact (866)
902-9690 for assistance.
The depth stop block is a feature provided
to allow for full-depth cuts or non-through
cuts used to cut grooves.
To get a full-depth cuts
Step 1: Unplug the saw.
Step 2: Make sure the saw head is on the
full “Up” position by itself.
Step 3: Raise depth stop block (Fig. 14).
Step 4: Press down the saw head to get
full-depth cuts.
For non-through cuts
(Fig. 15).
Step 1: Unplug the saw.
Step 2: Make sure the saw head is on the
full “Up” position by itself.
Step 3: Turn down the depth stop block.
Step 4: Plug the saw and press down the
saw head to cut and check the depth,
adjust the cutting depth to requirement by
turning the depth stop adjustment bolt.
Step 5: Tighten the lock-nut.
USING THE LED WORK LIGHT
This miter saw is equipped with a LED
work light on the left side of saw head (Fig.
16), there is a switch on the main handle.
USING THE LASER GUIDE
WARNING Do not attempt to repair
or disassemble the laser. If unqualified
persons attempt to repair this laser
product, serious injury may result. Any
repair required on this laser product
should be performed by an authorized
service center (866) 902-9690 for
assistance.
This miter saw is equipped with a laser
guide on the fixed safety guard (Fig.17),
there is a switch on the main handle.
1. Mark your work piece with a pencil at
the point to cut.
2. Press the laser switch to activate the
laser line.
3. Align your pencil line to the laser line.
4. Clamp your work piece in place using
the work piece clamp.
5. Follow the cutting instruction to cut.
FIG. 14
1
2
FIG. 16
FIG. 17
ASSEMBLY AND ADJUSTMENT
FIG. 15
