Page 28
See the following table for correct angle settings and correct positioning of the crown
molding on the miter table.
Key Miter Setting Bevel Setting Type of Cut
IL
31.6° Right
33.9° Left
Inside corner - Left side
1. Position top of molding against fence.
2. LEFT side is finished piece.
IR
31.6° Left
33.9° Right
Inside Corner - Right side
1. Position top of molding against fence.
2. RIGHT side is finished piece.
OL
31.6° Left
33.9° Right
Outside Corner - Left side
1. Position top of molding against fence.
2. LEFT side is finished piece.
OR 31.6° Right
33.9° Left
Outside Corner - Right side
1. Position top of molding against fence.
2. RIGHT side is finished piece.
TO REMOVE THE BLADE
WARNING Before performing any
maintenance or cleaning work, always
unplug the saw!
WARNING Failure to unplug the saw
could result in accidental start up,
which may cause serious injury.
NOTE: Always wear gloves when
handling or working near blade which
located on the safety guard.
Step 1: Unplug the saw.
Step 2: Raise the saw arm and lift the
moveable safety guard.
Step 3: Loosen screw with a Phillips
screwdriver(not included)(Step A2,Fig. 36).
Step 4: Lift and hold the lower blade guard
to expose the threaded blade.
Step 5: Press and hold the spindle-lock
button, and rotate the blade at the same
time until the blade is locked into position.
Step 6: Use the blade wrench (included) to
turn the threaded blade screw clockwise.
Remove the blade screw and the outer
blade flange.
Step 7: Remove the blade, wipe the blade
flanges and spindle to remove any dust
and debris, put the outer blade flange back
and tighten the blade screw (Fig. 36).
TO INSTALL THE BLADE
WARNING Failure to unplug the saw
could result in accidental start up,
which may cause serious injury.
NOTE: Always wear gloves when
handling or working near blade which
located on the safety guard.
Step 1: Unplug the saw.
Step 2: Loosen and remove the blade
screw and outer blade flange.
Step 3: Ensure that the inner blade flange
is properly installed.
Step 3: Match the arrow on the blade with
the arrow on the upper blade guard. Make
sure that the teeth of the blade are pointing
downward. Install the selected blade by
sliding the blade into the upper blade
guard and then placing the blade in
position.
Step 4: Install the outer blade flange, make
sure that the flat side of the blade flange is
placed against the blade (Fig. 36).
Step 5: Press and hold the spindle-lock
button, and use the blade wrench to turn
the blade screw counter-clockwise until the
lock engages. Securely tighten the blade
screw.
Step 6: Rotate the blade screw guard into
position, and use Philips screwdriver (not
supplied) to securely tighten the screw.
Step 7: Make sure that the spindle-lock
button is released so the blade will rotate
freely.
Step 8: Lower the saw arm, and check the
clearance between the blade and the miter
table. The blade should rotate freely.
FIG. 36
OPERATION
