Page 14
UNPACKING
WARNING This saw is heavy, to
avoid back injury when unpacking,
grasp the carrying handle firmly, lift
with your legs, not your back, and get
help when necessary.
WARNING Check this saw carefully,
if any parts are damaged or missing, do
not operate this saw and contact (866)
902-9690 for assistance. Failure to heed
this warning could result in possible
serious personal injury.
WARNING Do not attempt to modify
this miter saw or create accessories not
recommended for use with this saw.
Any such alteration or modification is
misuse and could result in a hazardous
condition leading to possible serious
personal injury.
WARNING Do not connect to a
power supply until assembly is
complete. Failure to comply could
result in accidental starting and
possible serious personal injury.
This miter saw requires assembly.
Carefully lift the saw from the carton by
the carrying handle with two (2) hands
and put on flat ground.
The saw arm is secured in the “Down”
position in carton. To release the saw
arm, push down on the top of the saw
arm, and pull out the locking pin, use the
handle to lift the saw arm.
Inspect the miter saw carefully to make
sure that no breakage or damage
occurred during shipping.
The saw is factory set for accurate
cutting. After assembling it, check for
accuracy as directed in the adjustment
section of this manual. If shipping has
influenced the settings, refer to specific
procedures explained in this manual.
NOTE: Do not discard the packing
material until you have carefully
inspected and satisfactorily operated
the miter saw.
TRANSPORTING THE SAW
WARNING Failure to unplug your
saw could result in accidental starting
causing serious injury.
WARNING This saw is heavy, to
avoid back injury, lift with your legs, not
your back, and get help when
necessary.
Step 1: Set the saw head at miter 0°, bevel
0° and tighten the miter detent and the
bevel lock knob.
Step 2: Return and lock the upper sliding
fence in place.
Step 3: Lower the saw arm and lock the
saw arm in the “Down” position by
inserting the locking pin.
NOTE: The locking pin is used for
carrying and storage only.
Step 4: To get a balance point, pull and
slide the saw head toward operator and
tighten the slide-lock knob.
Step 5: Carefully lift the saw by holding the
carrying handle (Fig. 4).
Step 6: Move it to required position.
MOUNTING THE SAW
WARNING Before mounting the saw,
always disconnect from the power
source. Failure to unplug your saw
could result in accidental starting
causing serious injury.
This miter saw is recommended to be
mounted on a firm supporting surface,
such as a workbench. Four large bolt holes
have been provided in the saw base for
this purpose (Fig. 5).
Step 1: Place the saw onto the workbench.
Step 2: Align the four mounting holes
located on the saw base with the ready-
made holes of the workbench.
Step 3: Tighten the saw onto the
workbench securely with 4 sets hex bolt kit
(3/8”, not supplied, including bolt, screw,
flat washer and spring washer). Bolts
should be of sufficient length.
Note: Carefully check the
workbench after mounting to make sure
that no movement can occur during
use. If any tipping, sliding, or walking is
(Continued on page 16)
ASSEMBLY AND ADJUSTMENT
FIG. 4
