Refer to the operating instructions.
1.3.4. Setting of Warning Sign for Safety
During instruction, maintenance and repair, follow the instructions below to prevent non-specialist
personnel from causing misuse or accident:
•
Obvious signs should be placed at front switch and rear-level switch to prevent accidents caused
by false switching.
•
Warning signs or tapes should be set near operating areas.
•
The system must be reinstalled after maintenance or operation.
1.3.5. Measuring Equipment
To ensure the electrical parameters to match requirements, related measuring equipment are required
when the system is being connected or tested. Ensure that the connection and use matched
specification to prevent electric arcs or shocks.
1.3.6. Moisture Protection
It is very likely that moisture may cause damages to the system. Repair or maintaining activities in wet
weather should be avoided or limited.
1.3.7. Operation after Power Failure
The battery system is part of the energy storage system which stores life-threatening high voltage
even when the DC side is switched off. Touching the battery outlets is strictly prohibited. The inverter
can keep a life-threatening voltage even after disconnecting it from the DC and / or AC side. Therefore,
for safety reasons, it must be tested with a properly calibrated voltage tester before an installer works
on the equipment.
1.3.8. Information on environmental conservation and recycling
This Symbol indicates that the marked device must not be disposed of as
normal household waste. It must be disposed of at a collection center for the
recycling of electric and electronic equipment.
08
1.3 Safety Introduction
1.3.1 Manual Keeping
This manual contains important information about operating the system. Before operating, please read
it very carefully. The system should be operated in strict accordance with the instructions in the
manual, otherwise it can cause damages or loss to equipment, personnel and property. This manual
should be kept carefully for maintenance and reparation.
1.3.2 Operator Requirements
The operators should get a professional qualification, or be trained.
The operators should be familiar with the whole storage system, including compositions and working
principles of the system.
The operators should be familiar with the Product Instruction.
While maintaining, the maintainer is not allowed to operate any equipment until all the equipment has
been turned off and fully discharged.
1.3.3 Protection of Warning Sign
The warning signs contain important information for the system to operate safely, and it is strictly
prohibited to torn or damage them. Ensure that the warning signs are always well-functioned and
correct placed. The signs must be replaced immediately when damaged.
This sign indicates a hazardous situation which, if not avoided, could result in
death or serious injury!
The GreenE 8K/10K/12K must not be touched or put into service until 5
minutes after it has been switched off or disconnected to prevent an electric
shock or injury.
This sign shows danger of hot surface!
User Manual
09
User Manual
