Masport UJ102, Руководство пользователя

Страница: 56 / 64

56
105
6.4 | LUBRICATION
Lubricate the machine according to figure 6.4 and the table below. In the event that the machine is operated in very dusty or sandy
operating conditions, lubricate more frequently.
Ball bearings of the tension pulleys, guide pulleys and bearings on the mowing deck are self-lubricating.
Prior to starting lubrication, the engine must be turned off and all moving parts of the machine must be still.
6.4
Symbol Explanation Activity
Plastic lubricant A00 ---
Oil SAE 30 ---
50
Interval in hours ---
(1) Rotating central pin of the axle housing Lubricate through oiler
(2) Bearings of both front wheels and pins of the axle housing Lubricate through oiler
(3) Angle joint connecting steering draw rods Remove and lubricate
(4) Rotating points of pedals on both sides of the machine Lubricate without removing
(5)
Bolt of the mowing deck elevation draw rod Lubricate without removing
(6)
Half axles of the rear wheels (transmissions)
Remove the wheel and
lubricate
(7) Steering draw rod ball pan Lubricate without removing
(8) Rotating points of the mowing deck elevation mechanism Lubricate without removing
(9)
Cogged steering segment, eccentric and angle joint of the steering draw
rod
Lubricate without removing
(10) Front wheel pin Lubricate through oiler
(11) Angle joint connecting steering draw rods Remove and lubricate
Do not allow oil and lubricants to come into contact with the drive belts and their pulleys. Thoroughly wipe the area around the
lubricated parts before and after lubricating.
Prior to putting the machine out of operation for an extended period of time, thoroughly lubricate all locations shown on the picture,
particularly however the half shafts of the front and rear axles.