Masport UJ102, Руководство пользователя

Страница: 45 / 64

45
93
5.5.2 STOPPING TRAVEL
The forward/reverse travel of the machine is stopped by gradually taking your foot off the travel pedal and subsequently
stepping on the brake pedal .
In the event that cruise control is engaged and the brake pedal is stepped on, it automatically moves to the neutral position. The
braking distance is shorter than 2 m.
5.5.3 TRAVELLING SPEED AND MOWING GRASS

It generally applies that the wetter, higher and more dense the grass is , the lower the travelling speed that should be used.
When the machine is travelling at high speed or when under large load, the rotation speed of the blades is reduced, the quality of
the cut is worse and the ejection chute may become clogged. Under such conditions always set the engine to maximum power.

If the grass is very high , it is necessary to mow it several times . First mow at maximum elevation and with narrower mowing
coverage width if necessary. The second run can then proceed at the required mowing height.

In the event that the 110 cm mowing deck is used for mulching, it is necessary to very
carefully adjust the speed
to the height
of the mulched vegetation respecting the significant load that this can place on the engine in this mode! The higher the grass,
the lower the travelling speed.

We recommend mowing in the parallel or cross direction . Covering the previous coverage of the machine increases the
effectiveness of the blades and will improve the appearance of the mowed area.

When travelling over uneven terrain the travelling speed may fluctuate.
Recommended travelling speeds of the machine based on conditions:
Condition of vegetation Recommended speed
High, dense and wet 2 km/hour
Average conditions 3 – 5 km/hour
Low, dry vegetation < 5 km/hour
Travelling without the mowing deck engaged < 8 km/hour
5.5.4 TRAVELLING ON A SLOPE
The UJ102 riding mower may work on slopes with an incline of up to 12° ( 21% ).
When working on a slope it is necessary to adhere to the following
fundamentals:

Pay increased attention when travelling on a slope.

Always use a slower travelling speed.

Only travel perpendicular to the contour, i.e. up and down. Travelling in the
direction of the contour is possible with extra attention only when turning
the machine. If at all possible, avoid travelling along the contour.

When turning ensure that a wheel does not drive over an elevated obstacle
(rock, tree root, etc.)

Travel slower when travelling down a slope or over obstacles. Pay special
attention when turning and turning around on slopes.

If you stop on a slope, always use the parking brake.
Right
Max 12
(21 )
o
%
Wrong
When overloading the machine by travelling on slopes over 12° ( 21% ) there is a risk of serious damage to the gear box. The
manufacturer is not responsible for damage caused in this way.
94
5.6 | EMPTYING THE GRASS CATCHER
5.6a
The full level of the grass catcher is signalled by the full grass catcher flap. It is possible to regulated the full level of
the grass catcher by moving the sliding part of the flap (extending or shortening the arm).
(1) Sliding part extended = grass catcher filled to minimum
(2) Sliding part retracted = grass catcher filled to maximum
Procedure for emptying:

Drive the machine to the location where you wish to empty the grass catcher. Stop the machine and apply the brake. If on
a slope, use the parking brake.

Deactivate the mowing deck by pushing down the activation switch.

If the AUT/MAN switch is installed on the machine, leave this switch in position “ AUT ”.

Set the throttle lever to position “
MIN
”.

Slide the grass catcher dump lever handle completely upwards (1) and tilt it down (2) to tip out the grass catcher,
allow it to empty freely, slowly release it and tilt it back.
5.6b