Martin Imager Series, Руководство оператора

Страница: 30 / 84

30 Programming using the optional infrared remote control
1 Press [menu] to return to the top level of the menu.
2 Scroll to S A in the top level of the menus on the control panel and press
[enter].
3 Scroll to r u n and press [enter].
4 Scroll to O f f and press [enter].
5 Press [menu] to return to the top level of the menu.
Enabling infrared programming
Perform the following steps in this order:
1 Only the first fixture on the data link can have an IR receiver. Insert the
receiver module into the serial data In socket. Position the sensor arm as
desired but avoid turning it more than necessary.
2 From the top level of the menu, scroll to P r o , press [enter].
3 If this fixture:
• Does not have the IR receiver installed, scroll to r C r . Press [enter].
• Has the IR receiver installed, scroll to r C S . Press [enter].
4 Press [menu] to return to the top level of the menu.
5 Select A d r and press [enter]. Select an IR fixture address from 0 to 9 and
press [enter]. Note that if you have multiple fixtures that will run the same
stand-alone scenes it might be a good idea for them to share the same IR
fixture address. This will save time when programming, as they will all
receive and process the scene programming instructions simultaneously.
6 Press [menu] to return to the top level of the menu.
7 Stand 2 meters (6 ft.) away from the fixture, point the remote control at the
receiver, and press the lamp power button. If there is no response, try the ID
button. If there is still no response, reverse the sensor head by rotating the
sensor arm 180° and folding it over.
Remote control commands
Important! The luminaire will acknowledge the receipt each valid IR
command with a slight change in intensity.