MARLOW-HUNTER MH31, Руководство оператора

Страница: 57 / 267

Limited Warranty
3.9
MARLOW-HUNTER, LLC
P.O. BOX 1030 – ALACHUA, FL 32616
PRE-DELIVERY
SERVICE RECORD
IMPORTANT:
This completed report is required for processing of claims for warranty adjustment. Please forward immediately.
DEALER
NAME OWNER
NAME
ADDRESS ADDRESS
CITY STATE/ZIP CITY STATE/ZIP
HULL # YEAR SIZE ENG # ENGINE MAKE
BEFORE LAUNCH PROCEDURE:
DEALER OWNER
1. Prop Size Shaft Size
2. Prop Rotation
3. Prop installed property with cotter pin in shaft
4. Shaft turns freely
5. Shaft aligned in shaft log tube
6. Shaft alignment in relation to strut
7. Engine intake thru hull clear and installed properly
8. Pet-cocks closed on engine
9. Rudder swings freely – no binding or hard spots
(check with wheel)
10. Emergency tiller steering system, complete operational check
with owner
11. Primary steering system, complete operational check
12. Cockpit seat hatches lift smoothly
13. Companionway sliding hatch and door works smoothly
14. Check keel bolts for tightness
15. Hook up and tighten battery cables
16. Check hose clamps on engine pickup, engine exhaust, vanity
drain, galley drain, fresh water system, toilet hoses and bilge
pump – A/C – genset
17. Electrical equipment operational:
( ) Running lights ( ) Cabin lights ( ) Anchor light
( ) Steaming light ( ) Stern light ( ) Courtesy lights
18. Check bilge pumping system – operational
19. VHF radio operational
20. Mast wire tube properly sealed
21. Check optional dripless packing spring tension & set screws
BOAT IN WATER:
22. Check for leaks: rudder post, shaft log, stuffing box, strut bolts
and keel bolts
23. Check for thru-hull fitting leaks: engine pickup, galley sink
drain, toilet pickup, toilet discharge, knot/depth, A/C,
refrigerator
24. Check windows and deck hardware for leaks
25. Check opening ports and hatches for leaks
26. Check rub rail and deck joints for leaks
27. 110 dockside cord and receptacles OK
28. Toilet operates OK, intake open, outlet open, pumps OK
29. Pressure water system operates OK (let pressure stand for 15
minutes to see if pump goes on)
30. Hot water heater operation OK
31. Check stove system for leaks per manufacturer’s instructions
32. With fuel tank full, no leaks at fill pipe, overflow vent or any fuel
line connections or gauge
33. Drawers work smoothly
34. Doors work smoothly
35. Engine aligned .004 or less
36. Check and tighten all engine mount attachments
37. Check and tighten all engine flange and coupling bolts
BEFORE STARTING ENGINE:
38. Throttle control cable travel and brackets OK
39. Clutch control cable travel and brackets OK
40. Crank case oil level at full mark
41. Transmission oil level at full mark
42. Engine shut off OK
43. Engine water pickup OK
44. Bleed air out of fuel line
45. Check heat exchanger fluid level and overflow bottle
DEALER OWNER
AFTER STARTING ENGINE:
46. Oil pressure OK
47. Water flow out of exhaust
48. Check fuel line connections for leaks
49. No engine water or oil leaks
50. Idling speed OK, Max RPM OK
51. Gear shifts work properly – forward, reverse, neutral
52. Instruments register properly
53. Check stuffing box drip rate (3-4/minute)
54. Purge optional dripless packing assembly
55. Hour meter reading properly
OPTIONAL GENERATOR ENGINE:
56. Crank case oil level at full mark
57. Engine water pickup open
58. Check heat exchanger fluid level and overflow bottle if supplied
59. Bleed air out of line
60. Check flow out exhaust
61. Hour meter reading properly
RIGGING:
62. Mast steaming light OK
63. Spreaders properly secured
64. Shrouds and stays right length
65. Main and jib halyards right length
66. Jib fits properly
67. Main fits and operates properly
68. Topping lift, out haul, reefing system installed properly
69. Install windex
70. Main sheet and blocks OK
71. Jib sheet and blocks OK
72. Winch handles fit and winches smooth
73. Rigging properly tuned and pinned
74. Furling system operational
75. Traveler arch ground wire installed
FINAL CHECK:
76. All accessory equipment on board
77. All loose gear on board
78. Owner’s manual on board
79. Warranty registration form completed and signed
80. Owner familiarized with operation and warranty policy
81. Boat properly cleaned, interior and exterior
82. Owner advised to complete component warranty cards
83. All plexiglass hatches and ports free of scratches
84. All interior wood free of dents, dings and scratches
85. Interior cushions, bedding & curtains clean and free of defects
86. Exterior gelcoat free of defects
87. Fee of water intrusion above and below the water line
88. All electronic equipment calibrated and operational
89. Exterior wood free of defects
90. Life lines adjusted and secure
Dealer Signature: Date:
I have received, read and understand completely the Marlow-Hunter Limited Warranty for my boat.
Owner Signature: Date:
DEALER COMMENTS (Refer to check list by item #
Remove 2
nd
& 3
rd
Copies and Forward Form Intact. DISTRIBUTION: Original – Marlow-Hunter Service Dept., Canary – Owner, Pink – Dealer
FORM #300-16/0112