MARKEM Cimjet RFID, Руководство по эксплуатации и обслуживанию

Страница: 91 / 158

SECTION 5 Operating Modes
0855904enb 4/05
m
®
5–5
4.2 On Demand Mode Sensor Position
This option is used when the product conveyor is constantly
stopping and restarting, or sometimes slows down due to the weight
of the products.
In On Demand Mode , a Feed sensor triggers the feeding of the tag
and an Apply sensor triggers the application of the tag.
When the Apply sensor is triggered, Cimjet waits for the Apply
Delay Timer to elapse and applies the tag onto the pack.
The Apply sensor position and the Apply Delay parameter setting
determine the position of the tag on the pack.
The product’s pitch (spacing frequency) and speed determine the
position of the
Feed sensor.
The sensor must be mounted far enough away from the Cimjet
applicator (prior to the tag applicator) to allow a tag to be fed before
the product reaches the applicator. If this distance is greater than
the product pitch, steps must be taken to increase the feed speed or
to increase the product pitch.
The Apply sensor should be mounted as close to the applicator as
possible. This Apply sensor triggers the application of the tag onto
the pack. The location of this sensor will set the position of the tag
on the pack.
A user parameter ( Apply Delay ) may be used to delay the
application of the tag, but the zero delay tag position is set by the
sensor position.