MARKEM Cimjet RFID, Руководство по эксплуатации и обслуживанию

Страница: 83 / 158

SECTION 4 Restricted Access Mode User Guide
0855904enb 4/05
m
®
4–17
10.0 Feeder Parameters
These parameters configure options in the Cimjet RFID for tag
adjustment, motor speed, and optic sensor position.
Table 4–4 Restricted Setup/Set Parameters/Feeder
Parameter Description
Darkness %*
Default: 100
Backfeed Speed*
Default: 150
Feed Adjust
Default: -50 Adjusts the position of the leading
edge of the tag on the peel edge
Backfeed
Default: 0 Backfeed must remain at 0 for
Cimjet RFID.
Ribbon Sensor*
Feed Speed
Default: 150
Feed Speed (mm/s) is the time
taken for the tag to pass the nip
roll.
Optic Position
Default: NEW
Sensor location prevents tag gap
from stopping in front of sensor
(refer to
Section 6,
paragraph 3.0 ).
Optic Adjust
Default: 0
If the tag gap happens to stop in
the
Tag Gap sensor, this will
cause feed problems. In cases
where this happens, the
Tag Gap
sensor can be moved to a new
position 10mm (.394”) lower.
The
Optic Adjust parameter
should then be adjusted by -100
to compensate.
NOTE: This parameter should
not be adjusted for any other
reason.
Direction*
Default: 0
Ribbon Save*
Default: None