MARKEM Cimjet RFID, Руководство по эксплуатации и обслуживанию

Страница: 89 / 158

SECTION 5 Operating Modes
0855904enb 4/05
m
®
5–3
3.0 Connecting External Sensors
3.1 Wiring the Sensors
The Feed and Apply sensors are connected to Cimjet RFID via the
9 pin D type connector X23 on the rear of the machine.
Depending upon the installation, different wiring configurations can
be used.
In simple applications using only Feed and Apply sensors, wire
the sensors directly to X23 .
In more complex applications that require a number of
connections to X23, it is recommended that a single multi-core cable
be run in conduit to a junction box. The junction box can be mounted
at a convenient position and individual cables run to the sensors and
conveyor control, etc.
For full connection details, refer to Section 7 – Technical
Information
.
3.2 Testing the Sensors
Viewing the status of the inputs in the Engineer Mode Diagnostic
screen will test the functionality of the sensors. Take the Cimjet out
of
Auto Mode ; depress the Engineer Mode button, then depress
the Display I/O button. The status of the inputs can then be seen.
Passing an object in front of the sensor should cause the status to
change from
OFF to ON .