Marinediesel 5L V8, Руководство пользователя, Страница: 5 / 248

3
Warning: DO NOT USE STARTING AIDS SUCH AS STARTING GAS; ETHER OR
OTHER. (this will void any warranty.)
3. Turn the ignition key to the CRANK position to start the engine. If the engine doesn’t
start in 15 seconds, wait for 30 seconds and go back to step 2.
As soon as the engine starts, let it run at idle while checking oil pressure and volt reading.
It’s not unusual with smoke from the exhaust system just after start-up but this will stop
once the engine reaches operating temperature. Glow system will automatically afterglow.
Recommended cruising rpm for all Marinediesel engines is 2700-3200rpm although the
maximum rated effect is at a higher rpm. It is necessary to choose a propeller that will
allow the engine to reach maximum engine rpm at WOT to not inflict unnecessary load on
the engine, which could effect longevity
and void warranty . Do not exceed maximum
recommended engine rpm as the pump reduces the amount of injected diesel after this rpm
and engine power drops quickly.
Winter storage
x
Oil system
Change oil on the supercharger (only SC models without commercial SC cooling), se
technical maintenance specifications. Drain the oil from the engine, either by removing
the oil plug in the oil pan or by a suction tube down the dipstick tube; remember it’s
always recommended to do this when the engine is at operating temperature. Tighten the
plug, clean the oil dipstick and reinsert it in the tube. Then remove the oil filter and
replace it with a new unit (don’t forget to prelubricate the seal ring on the filter and prefill
the filter with oil) tighten hard with manual power. Refill the engine with new oil
according to technical maintenance specifications. Check the oil level on the dipstick and
if necessary add more oil to reach the correct oil level. Start the engine and run it for a few
minutes so that the new oil can lubricate all moving parts. Turn off the engine and recheck
the oil level on the dipstick, again add more oil if necessary.
x
Fuel system
Check all hoses, clamps and fittings for leakage and wear, replace if necessary. Make sure
the fuel tank is full to prevent water contamination. Add “water repellent” isopropanol to
the fuel system. Remove and replace the fuel filter.
x
Cooling – system
Start the engine and run antifreeze mix through the raw water system. Check the freeze
protection of antifreeze in the freshwater cooling system. If you need to add antifreeze
make sure you allow the engine to run up to operating temperature allowing the