44 - Installation manual - Eletta
®
•
Reposition the rivets for fastening the tarpaulin and the PE band to the support.
•
After the replacement of the bow, the tarpaulin is ready for use again.
Note:
In case of electrically operated handling system remember to restore the emergency case standby by unlocking
using the relative key.
5.2 Tarpaulin replacement
•
Remove the rivets positioned on the tarpaulin outside which fasten the
tarp to the supports of the various bows;
WARNING!
For carrying out certain maintenance work the access to the internal space of the tipper body is
required. Make sure that the internal space is empty and clean to avoid any sliding and falling.
Wear suitable protective clothing.
DO NOT WALK ON THE TARPAULIN!
The manufacturer denies any responsibility.
•
On the frontside of the tipper body remove the aluminium flat bar which fastens the tarpaulin.
•
Inside the tipper body remove the cable ties which fasten the tarpaulin to the bows
•
Remove the damaged tarpaulin.
•
Proceed to position the new tarpaulin.
•
Inside the tipper body, fasten the tarpaulin to the various bows by using common cable ties for standard PVC
tarpaulins.
CAUTION!
For fire-resisting PVC tarpaulins the application of standard cable ties is not permitted. Demand the
proper cable ties for fire-resisting tarpaulins from the manufacturer.
The manufacturer denies any liability.
•
Reinsert the plastic band inside the tarpaulin lateral sleeves
•
Reposition the rivets that hold the tarpaulin in place.
•
Tighten up the front part of the tarpaulin.
•
Fasten the tarpaulin on the top of the gear housing by employing the
specific clamping plate and rivets.
•
Cut off the excess part of the tarpaulin.
5.3 Steel cable replacement
For replacing the steel cables refer to paragraph 3.4.
