Installation manual - Eletta
®
- 13
3.3 Driving system installation - hand-operated version
The covering handling system must be placed on the front side of the tipper body next to the cab guard.
3.3.1 Versatility of the covering system
In order to meet the various market requirements our covering system has been designed and manufactured for being
installed with every kind of tipper body.
The entire system is intended for fastening with screws (supplied). It is not necessary to weld any part to the tipper body,
allowing this way an easy maintenance in case of accidental breakage.
Note:
Normally, to facilitate the manual handling, the installation of the cover provides that the control element is installed
on the left side (with respect to the direction of travel of the vehicle) of the cab guard: it is, in fact, more accessible for
the driver leaving the vehicle.
In this manual, reference will be made to standard assembly of the covering system (on the left side referring to the direction
of travel).
For the installation on the opposite side it will be sufficient to perform the operations mirrored on the opposite side, being
careful to place the correct command group.
3.3.2 Processing and preparation of the cab guard
•
Drill the holes (Ø 9) of the fixing seats according to the dimensions shown in the following drawings:
Right view
Superior view
–
right side
Superior view
–
left side
•
Drill the holes (Ø 9) of the seats for the front attachment of the coverage extendable and reductor carters, according to
the measurements shown in the following drawing:
Frontal view
At this point the cab guard is ready for housing the various components as indicated below.
