Installation manual - Eletta
®
- 41
4.2.3 Automatic
“Wheel
-
Hooking System”
With this lateral closure system, the covering hooks automatically into the
respective lower supports fastened on the side of the tipper body, with a
“ROL
L
ING” coupling.
When the tipper body is covered the tarpaulin stops automatically and the vehicle
is ready for moving on the road.
For installing it, proceed as follows:
•
Move the covering and cover the tipper body entirely.
•
Define the fastening points of the tarpaulin.
Generally, for fastening the covering, 2 or 3 wheel hooks, installed at the same
heights, are planned to be evenly distributed along the side of the tipper body.
The number of wheel hooks is in any case not binding as it can change according
to the length of the tip
per body or the customer’s requirements.
Nota:
The positioning of the wheel hooks is essential for the proper working of the hooking system.
•
Fasten the wheel (1) on its support (2) with the
supplied screw (4) and self-locking nut (5).
•
Lean the wheel hook support (2) against the
lateral side of the bow support.
•
Fasten the wheel hook support with the supplied
screws (7) and nuts (6).
Note:
Apply medium threadlocker Loxeal 54.03
for the supplied screws.
After having defined the wheel hook height, the
lower support can be fastened on the tipper body
as follows:
•
place the support (4) 6 mm up from the wheel
hook;
•
drill the board wall of the tipper body and
fasten the support with the supplied rivets (5).
Now the positioning of the remaining wheel hooks can be done.
WARNING!
From now on, the even distribution of the wheel hooks and respective supports is the decisive factor for
a proper working of the covering system.,
