34 - Installation manual - Eletta
®
3.11.5 Unfold the Eletta® tarpaulin for covering the tipper body
In the starting position of the system, the tarpaulin is folded on the front part of the tipper body. To unfold it, operate as
follows:
•
Check that the upper edges of the tipper body are free from any obstacle.
•
Remove all elastic strings (if provided for the version installed on your vehicle) from the front hooks so that the covering
can move freely.
•
Insert the key in the emergency pushbutton.
•
Turn the key in CLOCKWISE direction to unlock the emergency pushbutton for giving the consent to start the machine:
When the Motor Control Unit is activated, it gives off an acoustic signal.
On remote control
: PRESS THE PUSHBUTTON no. 2 (COVERED)
On Motor Control Unit
: PRESS THE PUSHBUTTON no. 5 (COVERED)
•
Unfold the tarpaulin completely and release the control pushbutton. The Motor Control Unit is equipped with an
automatic motor shut-down system when covering reaches the end stop.
•
Close the covering on the rear side (in case of automatic rear closing system this operation takes place automatically).
•
Hook the elastic strings into the lateral hooking points to fasten the tarpaulin for the transport way (if provided for the
version installed on the vehicle).
•
Press the emergency mushroom pushbutton and remove the key.
•
Carry out a quick but attentive control, especially of the automatic hooks, to verify that everything is in good order before
moving the vehicle on the road.
3.11.6 Interruption of machine operations
For stopping the covering moving, release simply the control pushbutton on the Motor Control Unit or on the remote control.
3.11.7 How do you stop the machine in case of emergency?
For stopping the tarpaulin motion, release simply the control pushbutton on the Motor Control Unit or on the remote control.
•
For setting the machine in
EMERGENCY STOP
press instinctively the mushroom pushbutton stated as no. 6 on the
Motor Control Unit.
CAUTION!
It is strictly forbidden to leave the machine unattended while the system is active.
The manufacturer denies any responsibility.
3.11.8 Restoring of standard operative conditions
CAUTION!
Before restarting the machine, correct the situation causing the event.
For restoring the machine after an emergency situation and after having pressed on the
red mushroom pushbutton no. 6, proceed as follows:
•
Insert the unlocking key in the emergency pushbutton of the Motor Control Unit
•
Turn the key in clockwise direction and pull out the pushbutton.
