18 - Installation manual - Eletta
®
•
Introduce the end of the rope at the front of the drive pulley on the lateral drive
unit;
The bows that support the cover are provided with steel feet with low-set bushings to allow the passage of the rope
(see figure below). A plastic sliding pad is fixed to the bottom to allow the cover to run along the edge of the body.
•
Pass the rope through the bushings on all the feet and leave 10-15 cm length of rope out of the last one.
Note:
Pay close attention while fixing the pulling bow, because a misalignment could compromise the covering workings.
Now proceed with the lower end of the steel cable:
•
Lead the lower end of the wire rope to the back of the body;
•
Wind the rope around the rear transmission pulley (1);
•
Lead the end of the wire rope back to the drawing (2).
Note:
Ensure that the bow keeps as perpendicular as possible to the board walls for avoiding any subsequent adjustment
service.
1
PAD
BUSHING
10:15cm
