Manitowoc Grove TMS9000-2 Series, Руководство по обслуживанию

Страница: 176 / 408

4-32
Published 01-14-2021 Control # 707-01
SUPERSTRUCTURE TMS9000-2 SERVICE MANUAL
4. Secure the strips and wear pads in place with the plates
(13, 14).
5. Lower Tele 2.
6. Install the wear pads (3, 4).
7. Install the strips (10).
8. Secure the strips and wear pads with the plates (12).
9. Install the rope protection bar (2).
10. Install the guide (162).
11. On the opposite end of Tele 1, install sliders (40) and fill
plates (41, 42).
12. Install wear pads (44, 45) and plates (46, 47).
13. Install sliders (36) and plates (37, 38).
14. Install the guide pilots (39).
15. Install the sliders (33) and plates (34, 35).
16. Place the wear pad (29) on the section and insert ten
strips (32) inside.
17. Secure the wear pad (29) with the plate (30).
18. Install the opposite wear pad (62), strips (32) and plate
(30).
19. Assemble the lubrication hoses (53, 54, 55) and connect
to the wear pads (29, 62).
20. Attach the thin nuts (57) and pipe unions (56) to the
lubrication hoses and secure the hoses to the tabs
inside the section.
21. Install the locking unit assemblies (26, 27).
22. Insert the telescope cylinder assembly into Section 1.
23. Install the tele power cable strain relief (2),
(Figure 4-18).
24. Install the tele power plug (1), (Figure 4-18).
25. Insert Section 1 into the Base Section just far enough to
measure the gaps between the sliders and wear pads
and the Base Section. The gaps should be no greater
than 1.52 mm (0.06 in). Adjust the gaps by adding or
removing plates or using thicker or thiner sliders and
wear pads.
26. Insert Section 1 into the Base Section half way.
Fo
r
Reference
Only