Manitou STACKY 10 FR D28, Руководство оператора

Страница: 17 / 60

1-13
STACKY operating and safety instructions 2012.12
D - PICKING UP AND SETTING DOWN A LOAD
Lifting and lowering are controlled by means of two buttons situated on the tiller
arm (1) and (2) (fig . D1) . These controls are duplicated to be equally accessible for left
or right hand use .
- To lift the load, press button (1) (fig . D1),
- To lower the load, press button (2) (fig . D1) .
E - SETTING-DOWN A LOAD IN A STORAGE STRUCTURE
- As you approach the storage structure, slow the stacker to arrive at moderate speed,
- Position the stacker in front of its storage location,
- Check that no obstacle risks to be caught by the load, the fork or the tool during
lifting,
- Raise the load so that the underside is higher than the bearing surface (1) (fig . E1) .
Check that, when it is inserted into its housing, the load does not risk to catch any
lateral or horizontal part of the support structure .
- Operate a butterfly control switch to move slowly forward until the load is above
its intended position, taking care not to knock against the storage structure with
the stacker (2) (fig . E2),
- Slowly set down the load (3) (fig . E3),
- Check the lifting chain tension : if it is slack, the fork is resting on the storage
structure . Raise the fork slightly by lightly pressing the UP button,
- Ensure that the area of manoeuvre is unobstructed,
- Slowly reverse the stacker by operating a butterfly control switch to release the fork
(4) (fig . F3), checking that it will not catch any obstacle as it is lowered,
- Lower the fork or tool into the down position .
In order to avoid the risk of destabilising or overturning the stacker during these
operations, take care not to :
• catch the load or tool,
• hit the bearing surface with the fork or the tool,
• drag the fork or tool across the bearing surface.
3
4
E3
2
E2
1
2
2
D1
1
E1