Manitou STACKY 10 FR D28, Руководство оператора

Страница: 33 / 60

2-11
2012.12 Description - STACKY
DESCRIPTION
1 - MOBILE FRAME (duplex model only)
The lifting mast comprises a fixed part, the chassis, and a moving part, the moving frame . The moving part receives the carriage
onto which the tool is attached . A hydraulic cylinder slides the moving frame within the chassis . A drive belt/chain transmits the
translation movement of the cylinder to the moving frame and the carriage . According to the stacker model, the lifting stroke
is between 818 and 2740 mm .
2 - SLING ATTACHMENT POINT
This sling attachment point provided on the chassis is used for handling the stacker by (overhead) crane .
3 - CHASSIS
The chassis receives the carriage (simplex model) or the moving frame (duplex model)
that slides within it .
4 - TILLER ARM
The tiller arm controls and steers the stacker . It has a driving zone (2) (fig . 4) . In zones
(1) and (3) (fig . 4) the wheels are mechanically locked . When it is within the driving zone,
the tiller is used to move the stacker forwards or backwards by pushing the butterfly
control switches (23) up or down . When moving, the stacker must be behind the
operator . The stacker thus follows the direction of the operator .
5 - COVER FASTENING SCREW
The cover is fastened to the chassis by means of four screws . Two of these screws
are located on the fork side, the other two at the base of the tiller arm .
6 - DASHBOARD
The dashboard includes a charge indicator (13), an emergency stop button (14),
and the key switch (15) .
7 - DRIVE UNIT
This item comprises in particular an electric motor, a brake and the drive wheel . It is connected to the tiller arm that steers
the machine .
8 - STABILISER WHEEL
This caster wheel forms the fourth bearing point of the stacker .
9 - SUPPORT LEG
On the STACKY 10 FR and STACKY 14 stackers, the support legs are fixed . On the LE model, the spacing of the two legs is variable
between 900 and 1280 mm .
10 - ROLLER
11 - SUPPORT LEG ADJUSTMENT SCREWS (LE model only)
These four screw (1) and (2) (fig . 11) are used to alter the support leg spacing on STACKY LE stackers .
To adjust the support legs :
- check that the stacker is on level ground,
- sling the stacker,
- lift the stacker with an overhead crane,
- loosen lock nuts (1) (fig . 11),
- loosen screws (2) and (3) (fig . 11),
- adjust the support leg spacing, keeping them symmetrical,
- bring the screws into contact without tightening,
- set down the stacker,
- tighten screws (2) (fig . 11),
- tighten screws (3) (fig . 11),
- tighten lock nuts (1) (fig . 11) .
12 - FORK OR TOOL (except STACKY 14)
The tool mounted on the stacker must be the appropriate tool for the task to be performed .
Only tools approved by MANITOU can be used on the stacker .
The tools are attached to the carriage by means of a hook and two M10 screws . Some tools are provided with a lifting ring
for ease of handling (jib, narrow-aisle fork) .
3
2
1
4
11
1
1
1
1
2
2
3
3