Manitou MT 1135 ST3B, Инструкция по эксплуатации

Страница: 114 / 159

3 - 11
A4 – FUEL PRE-FILTER
CHECK
IMPORTANT
Carefully clean the outside of the pre-filter and its holder, to prevent dust from getting into the system.
- Open the engine bonnet.
- Check for the presence of water in pre-filter tank 1 and drain if necessary.
- Place a receptacle under the drain plug 2 and loosen by two to three turns.
- Open bleed screw 3.
- Allow the diesel fuel to flow out until it is free from impurities and water.
- Retighten drain plug 2 and bleed screw 3.
A5 – BOOM PADS
CLEAN - GREASE
To be carried out every 10 hours during the first 50 hours service,
then once at 250 hours.
IMPORTANT
If the lift truck is used in an abrasive environment (dust, sand, coal, etc.) use lubricating
varnish (MANITOU reference: 483536).
Consult your dealer for this varnish.
- Fully extend the boom.
- Apply the grease with a brush (see: 3 - MAINTENANCE:
LUBRICANTS AND FUEL) to the 4 sides of the telescope(s).
- Telescope the boom several times in order to spread the coat
of grease evenly.
- Remove the surplus of grease.
1
2
3
647104
(13/06/2016)
MT
835
/ 1135
/ 1335
ST3B