Manitou 160 ATJ PLUS Euro 3, Инструкция по эксплуатации

Страница: 132 / 146

3-32
E5/1
E5 -
HYDRAULIC CIRCUIT STRAINER
CLEAN
- Drain the oil (see
§ D15)
-
Unscrew the six fixing screws 1 (Fig. E5/1) from the locking plate 2 (Fig. E5/1).
- Unscrew the strainer 3 (Fig. E5/2) from the container and clean it with a jet of
compressed air.
- Screw the strainer back into the container and refit the locking plate
2 (Fig. E5/1).
-
Fill with hydraulic oil (see
§ D6) (
see the “LUBRICANTS” section).
E6 - CONDITION OF THE CYLINDERS (LEAKS, RODS)
CHECK
- Check the condition of the cylinders. There must be no:
• Hydraulic leaks from the seals and the valve blocks
• Impacts on the cylinder rods
E7 - CONDITION OF THE CABLE BUNDLES AND THE CABLES THEMSELVES
CHECK
- Inspect the following sectors, check the condition of the bundles: no deterioration
and nothing loose.
• Base control console,
• Hydraulic block,
• Battery,
• Intermediate joint,
• Basket control console.
E8 - ENGINE SILENTBLOCKS (*)
CHECK
E9 - ENGINE SPEEDS (*)
CHECK
E10 - HYDROSTATIC TRANSMISSION CIRCUIT PRESSURES (*)
CHECK
E11 - START OF HYDROSTATIC TRANSMISSION CONTROL (*)
CHECK - ADJUST
E12 - MOVEMENT SPEEDS (*)
CHECK
*(Contact your dealer)
E5/2
1
2
3
547408 EN (15/05/2012)