Manitou 160 ATJ PLUS Euro 3, Инструкция по эксплуатации

Страница: 129 / 146

3-29
D14 -
IC ENGINE OIL
DRAIN - REPLACE
D15 -
IC ENGINE OIL FILTER
REPLACE
- Set the lifting platform on a horizontal surface, leave the engine running at tickover
speed for a few moments and then switch it off.
DRAINING THE OIL
-
Open the left-hand cover.
- Lay a receptacle on the ground
-
Remove the filling cap 2 (Fig. D15/2) to ensure good drainage.
- When draining is complete, screw the plug back in
Dispose of the drained oil in an environmentally friendly manner.
REPLACING THE FILTER
- Remove the engine oil filter 3 (Fig. D15/3) and throw it away, together with its
seal.
- Clean the filter support with a clean, lint-free cloth.
- Light oil the new seal.
- Refit the oil filter on its support.
Only tighten the oil filter by hand and then lock it with a quarter turn
from a filter wrench.
REFILLING WITH OIL
- Ensure that the plug 1 (Fig. D15/1) is in place and tight.
- Fill up with oil (see the LUBRICANTS section) via the filling hole 2 (Fig. D15/2).
- Wait a few moments for the oil to flow into the sump.
- Check the level with the dipstick 4 (Fig. D15/4).
- Start the engine and let it run for a few moments.
- Check for any leaks from the drain plug and the engine oil filter.
- Stop the engine, wait a few moments and check that the level is between the two
upper notches on the dipstick A (Fig. D15/4).
- Top up, if necessary.
D15/1
1
D15/2
2
D15/3
3
D15/4
4
A
547408 EN (15/05/2012)