Mami HomeGuard 32, Быстрый старт

Страница: 10 / 16

Using Wireless Sensors is simple provided you are aware of the following facts:
1 - The operating range may vary widely from one installation and location to another. As the radio receiver
is in the unit the position of the unit is critical and must be chosen accordingly.
2 - Detector and Remote control ID codes may be “learned” by the HomeGuard 32 by activating them while HOME GUARD 32
is in “ learning” mode . It is highly recommended that the detectors do not have identical codes if programmed manually.
By default all mami detectors come with a random code.
3 - Whilst Learning the different detectors please ensure that no other detector is transmitting or the HOME GUARD 32
will learn the wrong code.
4 - Only the ID code of different detectors and not channel information is used as identification in the HOME GUARD 32
Therefore in detectors with channel information ensure that channel bits 1 to 4 are in the off position .
5 - To save power a wireless detector transmits an alarm condition only for a short time (2 - 4 Seconds)
and designed not to transmit if continuous movement is detected.
6 - A detector will only transmit if either a 30 seconds (test mode ) or 3 minutes (normal mode) has
elapsed from the last detection.
How to TRIGGER different devices for ZONE allocation
To trigger the PIR for programming the User needs to
open the casing of the PIR and consequently send a
“Tamper” signal.
NOTE: A tamper signal is enabled only if bit 8 of the
DIPSWITCH in the device is OFF
.
1 2 3 4 5 6 7 8
ON
Switch Bit 8
OFF
To trigger the Door Guard the User needs to press the
Panic button. Refer to the instructions of the Door Guard
When opening a SILENTRON outdoor detector a
tamper signal is automatically transmitted . This can be
used to learn the code by the HOME GUARD 32. A
futher thansmission can be generated by pressing for
few seconds the tamper switch inside the casing .
Refer to the Silentron Instructions to locate the Tamper
Switch.
To Learn a remote control the user must push the panic
button (button 1).
How to learn a M.A.M.I. four channel remote.
How to Trigger a cRed wireless PIR detector
How to trigger a SILENTRON OUTDOOR Detector
How to trigger an MAMI DOOR-GUARD Detector
PANIC ACTIVATION
1
2 3 4
How to Trigger RoboGuard Detectors.
When opening the casing of a roboguard outdoor detector a tamper signal
is automatically transmitted . This can be used to teach the code to the
HOME GUARD 32. Refer to the unit Instructions to locate the Tamper Switch.
Note: RoboGuard Detectors can transmit at 3 second intervals if it is being
permanently triggered.
NOTE: WHEN TRIGGERING DEVICES FOR LEARNING, ONLY THE PANIC OR TAMPER SIGNALS WILL BE RECOGNIZED
WIRELESS DETECTORS and REMOTE CONTROLS
M000078 P8