Mami HomeGuard 32, Быстрый старт

Страница: 12 / 16

ALERTS
In the case that any of the sensors added to the system has a
battery low condition the sensor will transmit that condition to
the unit. The unit will light up the Trouble LED and sound an
alarm. The battery low zone will be displayed (either the zone
name or the zone number).
Battery Low
Lounge
BATTERY LOW ON SENSORS ALERT.
Battery Low
Zone - 5
In the case that any of the senors added to the system has a
Tamper condition the sensor will transmit that condition to the
unit. The unit will light up the Trouble LED, Tamper and the
zone will be displayed (either the zone name or the zone
number) and the alarm will be sound. The user may push the
star key and hold it down the tamper alarm will be cleared.
TAMPER!!!
Lounge
TAMPER ON SENSORS ALERT.
TAMPER!!!
Zone - 5
Clear Alerts:
The user simply pushes the star key and hold it for 2 seconds,
then the alerts will be cleared.
*
ALARMS
Alarms on the unit will occur when any of the 8 zones are triggered, the
panic on the remote was triggered or the panic on the keypad was
triggered.
When the unit goes into alarm, the unit will beep continuously for 1 minute
and every 30 seconds thereafter. The external trigger will pulled low for
30seconds on every new alarm. The LCD will display the name of the Zone
that went into alarm. All zone armed that goes into alarm will blink on the
bottom half of the LCD display. Example zone 3 is named “lounge” and if
this zone goes into alarm “lounge” will be displayed and zone, 3 of the level
will blink on the bottom half of the display. To cancel an alarm the user has
to disarm the unit.
If the Zone was not named the zone number will be displayed.
1
•X•3•X•X•6•X•8
LOUNGE
Blinking
1•X•3•X•X•6•X•8
ALARM ZONE-3
Blinking
When panic is activated, the system goes into alarm and the siren
output is activated on the Advisor, together with the on-board
buzzer. The display will show PANIC!!!.
PANIC!!!
To deactivate a panic the user must disarm the system.
To activate a Panic on the four button remote the user will have to
push button 1 as described in the figure.
On the Keypad the user can activate a panic by holding down the
hash “#” and star “*” key together.
* #
+
ARM LEVEL A
PANIC ACTIVATION
ARM LEVEL B
DISARM
1
2 3 4
PANIC ACTIVATION
M000078 P10