Mami HomeGuard 32, Быстрый старт

Страница: 5 / 16

- Supply Power: The unit operates from a 12 Volts DC, 1A Charger and/or a re-chargable 3.7V Li battery.
- Zones: 8 zones are available but up to 32 sensors may be distributed in these 8 zones .
- Detector/sensor Names: Individual names may be allocated to each of the 32 sensors /detectors, this helps the
end user to easily identify the zone which was activated. If the zone name is not programmed the Zone number will
be shown instead. Programming of the zone names is described in the section - “set Zone names”.
- Wireless Detectors/Sensors: The “ HOME GUARD 32 ” supports 5 different type of devices, these are:
- cRED (TM) wireless detectors
- SILENTRON (TM) Outdoor , dual technology movement detector
- DGII Door guard / Vibration sensor
- Photo sensitive Smoke detector
- Remote controls
To add wireless detectors please see the “ Add detectors” instructions under the Programming mode section
- Schedules: The “ HOME GUARD 32 ” provides 2 programmable Schedules to automatically arm and disarm the
system at a specific time. Schedules can be disabled individually.
A schedule can easily be bypassed for one day. (see Programming mode/ Schedules and schedule bypass)
- Wireless LED and buzzer indicator: All conditions are replicated on one more remote receivers called Advisrors.
Arm/disarm, alarm and panic status will be indicated by the onboard buzzer and LED on the Advisor.
- Radio Transmitter on board: A radio transmitter( 30/50 mt range) is mounted on board which could be used
to interface to many of MAMI standard products namely:
- The Gatto two channel (relay) receiver (16bits smartcode)
- 16 bits smartcode receivers compatible with all MAMI alarm panels. (Tracer, Minitracer, M6 ).
To adjust these parameters refer to Programing Options, Options, Transmitter interface.
- Detector Tamper: If any of the detectors are tampered with, the detectors will send out a Tamper Signal which
sounds an alarm notifying the user, the zone in which the detector is will be displayed.
- Detector Battery Low: If any of the detectors send a battery low signal the unit will illuminate the Trouble led and
buzz continuously. The device with the battery low will be displayed.
The battery low signal will only be received with the unit in the Disarmed state.
- Four Programmable Arming levels: The Programmable levels is a feature whereby the user can select which
zones are to be monitored when the system is armed. If a zone is not selected in that level the device will not be
monitored. This unit has four levels which can be modified under the programming mode (set level’s A,B,C,D).
- Warn Only mode : The unit has a “warn only” mode, in this mode the unit will chime on activation but no external
trigger and no transmission will be activated.
- Charging: The unit has a 3.7V 1800mAh LiPo battery on board , The unit requires a 12V charger to charge the
battery. The time required for a fully charge from a flat battery is approximately 6 hours.
- Battery Life: The battery has a running life span of up to a maximum of 5 days.
- Wireless Supervision: All Sensors attached to the unit are monitored should a sensor not check in or trigger
within 24 hours an alarm is activated.
- Alarm Log: Alarm log is capable of recording the last 64 events. The user can view the date, zone and device
that caused the event.
GENERAL INFORMATION
M000078 P3