Malibu Boats AirMAX 240, Инструкция по установке и настройке

Страница: 36 / 82

Chapter 3: Configuration
30
Malibu Networks AirMAX“ CPE/BTS
Transmit Power this reflects the transmission power of
the radio modem in milliwatts. The value should be
appropriate for the cell area size the CPE or BTS
operates in. Power level must be high enough
between the CPEs and BTS for proper
communication, and should only be reduced where it
might unduly affect another cell area. (Reducing
power level will reduce range.) If there are no
adjacent cell areas, the value should be set to the
maximum shown in Table 2 for the antenna in use.
You can change the power level in the
Configure web
page.
Warning:
When used with the ANT-
24-19-D 19 dBi directional CPE antenna,
the transmit power must not be set higher
than 50 mW (+17 dBm).
Radio this shows radio modem transmitter status as On
or Off.
Signal Strength a value from 0 to 100, where a higher
number indicates higher signal strength.
Signal Quality value indicates relative signal quality.
Cell ID a unique number used by CPEs to associate
with a BTS that has a matching SSID.
Table 2. Maximum Power Settings
Antenna Maximum Power
8 dbi Omni 100 mw (20 dbm)
12 dbi Omni 100 mw (20 dbm)
13 dbi Panel 100 mw (20 dbm)
19 dbi Panel 50 mw (17 dbm)
WARNING