![background image](http://html1.mh-extra.com/html/makita/mw001gz/mw001gz_instruction-manual_4247485010.webp)
10 ENGLISH
HOW TO USE
Installing or removing battery
cartridge
CAUTION:
Always switch off the appliance
before installing or removing of the battery
cartridge.
CAUTION:
Hold the appliance and the bat-
tery cartridge firmly when installing or removing
battery cartridge.
Failure to hold the appliance and
the battery cartridge firmly may cause them to slip off
your hands and result in damage to the appliance and
battery cartridge and a personal injury.
To install the battery cartridge, align the tongue on the
battery cartridge with the groove in the housing and slip
it into place. Insert it all the way until it locks in place
with a little click. If you can see the red indicator on the
upper side of the button, it is not locked completely.
To remove the battery cartridge, slide it from the
appliance while sliding the button on the front of the
cartridge.
►
Fig.6:
1.
Red indicator
2.
Button
3.
Battery cartridge
CAUTION:
Always install the battery cartridge
fully until the red indicator cannot be seen.
If not,
it may accidentally fall out of the tool, causing injury to
you or someone around you.
CAUTION:
Do not install the battery cartridge
forcibly.
If the cartridge does not slide in easily, it is
not being inserted correctly.
NOTE:
Up to two battery cartridges can be installed,
although the appliance uses one battery cartridge for
operation.
If you install two batteries, the appliance use the
battery on the right side in the figure first.
Basic operation
Turning on/off the appliance
Press the power switch button to start the appliance
with one beep. After starting the appliance, the control
panel displays microwave power of 500W, working time
of 0 and battery power information by default and all
button lights are on.
If there is no other operation within 3 minutes, it will be
shut down automatically, and the display screen and
button lights will all go out to enter the power off state.
After power on, press the power switch button to shut
down in any state, including heating.
Heating operation
There are two heating power levels; 500W and 350W.
Press the power selection button to switch between
500W and 350W. The control panel displays the corre-
sponding level.
After the power is selected, turn the time adjustment knob
clockwise to increase the time and counterclockwise to
reduce the time. The maximum setting time is 20 minutes.
After selecting the power level and time, short press the
start button to start microwave heating. When the heat-
ing is finished, a beep will sound to notify completion of
the operation.
After the microwave heating starts, short press the
pause/stop button to pause the heating.
To resume the operation during pause, short press the
start button.
To quit the operation during pause, short press the
pause/stop button. The remaining time is reset and the
appliance goes into standby mode.
NOTICE:
Do not repeat removing the battery car-
tridges immediately after the operation.
Doing so
several times does not cause a malfunction however
an error may occur if it continues.
This appliance is equipped with the cooling fan.
The cooling fan may work to cool the appliance after
the operation. Sound of air comes out when the
cooling fan is working. This is not malfunction of the
appliance.
NOTE:
The heating time can be adjusted during
heating.
NOTE:
The output power cannot be switched during
heating.
State of charge
The number of the bar in the battery indicators on the
control panel shows the remaining battery capacity.
Battery indicators
Remaining capacity
The remaining power is equal to or
more than 75%.
The remaining power is equal to or
more than 50% and less than 75%.
The remaining power is equal to or
more than 25% and less than 50%.
The remaining power is less than
25%.
Blinking
Charge the battery. *
*
Even if the battery capacity is remaining, the
control panel may blink to request charging. This
is not malfunction of the appliance.
Some of the battery may not be possible to oper-
ate when its capacity falls below a certain level
due to the specifications.
Содержание MW001GZ
Страница 3: ...3 2 1 Fig 7 ...
Страница 327: ...327 ...