4
English
INSTRUCTIONS FOR USE
If you are not sure about the correct
setting, start with a low temperature
setting and gradually increase the
temperature until you achieve opti-
mum results.
Always observe the safety instruc-
tions and applicable regulations.
Use only one hand to hold the tool,
do not place your other hand over the
air vents.(Fig. 1)
Do not use the holes on the tool
housing for the fall prevention pur-
pose at high location.
Icon
Description
Purpose
Reflector nozzle
Soldering pipes
Reduction nozzle
Welding, sleeve shrinking (heat concentrated over small area )
Wide-slot nozzle
Drying, thawing (heat spread over wider area )
Overlap welding nozzle
Welding
Solder sleeves reflector
Soldering
Welding nozzle
Welding
Pressure roller
Press the surface of working piece
Scraper
Stripping paint and varnish
Q
Make sure that the tool is switched off and the nozzle has cooled down.
Q
Falling down nozzle may ignite objects on the floor. Nozzles must be mounted firmly and
secure on the unit.
Q
Touching a hot nozzle can lead to serious burns. Before attaching or replacing a nozzle,
allow the unit to cool down completely or use a suitable tool.
Q
A hot nozzle can set a surface on fire. Place down hot nozzles only on fire-proof surfaces.
Q
An incorrect or defective nozzle can lead to heat accumulation and damage the unit. Use
only original nozzles according to the table that are suitable for your unit.
