6-10-2
Assembling
6-11
Plug cap
6-11-1
Disassembling
6-11-2
Assembling
[3] In case no connection or inconsistent connection, check the condition of Plug cap and Plug cap spring. Reassemble them or
replace them if they are disordered.
[4] Insert the end of Plug cap spring into the high voltage cable, and then return them back to the inside of Plug cap carefully
so as not to be disconnected.
[5] Check Plug cap and Plug cap spring to avoid poor connection causing the poor sparks of Spark plug.
Fig. 6-11-1-1
[1] Spray the lubricant into Plug cap.
[2] Turn and pull out high voltage cable of Ignition coil together with Plug cap spring.
Plug cap
Plug cap
spring
High voltage
cable
Lubricant
Plug cap
Fig. 6-10-2-1
[1] Temporarily assemble Ignition coil to Cylinder block assembly with two M4x20 Hex socket head bolt.
[2] Insert 0.3mm feeler gauge of 1R366 into the gap of Flywheel and Ignition coil and then loosen two M4x20 Hex socket
head bolts slightly. While pressing down Ignition coil, tighten M4x20 Hex socket head bolts carefully with the gauge stuck
to both Ignition coil and Flywheel.
[3] Remove 1R366 while turning Flywheel by hand counterclockwise, and then check if it turns smoothly without being stuck.
Ignition coil
0.3mm feeler
gauge of
1R366
Flywheel
Note:
Be sure to pull out 1R366
while turning Flywheel
counterclockwise.
M4x20 Hex socket head
bolt (2 pcs.)
Cylinder block assembly
23 / 40