P 12/ 13
Fig. 30
W
iring diagram
Switch unit (for Clutch)
lead wire holder
First, put the following lead wires from Controller
in place;
*wires to LED circuit
*wires to switch unit (for Clutch)
Then, with the lead wire holder, fix the lead
wires (orange, white, blue) from Controller to
Stator.
Route the following lead wires from Controller
between rib (E) and the inside wall of Housing;
*wires to LED circuit
*wires to switch unit (for Clutch)
At this time, place the lead wires so that the tape
is positioned beside Printed wiring board.
pin
rib (G)
rib (F)
rib (E)
Connector
Stator
Route the six lead wires (orange, black, white,
yellow, blue, red) from Controller to Stator
between rib (F) and rib (G).
Route the three lead wires
(orange, white, blue) from
Controller to Stator between
the pin and Stator.
Connector (to LED circuit)
Printed wiring board
Place Connectors and the sag
of lead wires in the space
between rib (E) and the inside
wall of Housing.
tape
inside wall of Housing
[2] Wiring Around Stator
