MyPower VG2000 V4 VoIP Gateway Installation Manual
Page
65 / 72
6.3.2 Ethernet Cable Connection
Straight-through Ethernet cable model: C1212-1002. Connect
the Ethernet interface by the following steps:
Step 1: Insert the one end of the Ethernet cable to FE0, FE1 or
FE2 Ethernet interface.
Step 2: Connect the other end of the Ethernet cable to the HUB,
switch, PC or other network devices.
Note
Check the identifier on the interface during connection to
avoid module or VG2000-64S VoIP gateway host damage
by inserting other interfaces. Check the host panel indicator
state when the system enters the normal work state. The
LINK indicator on indicates that the link is connected and
indicator off indicates that the link is not connected and
check the line in this situation.
6.3.3 POTS(FXS) Cable Connection
Insert one end of the RJ45 transfer cable to the
corresponding interface of the device.
