MyPower VG2000 V4 VoIP Gateway Installation Manual
Page
30 / 72
Note
1. The default configuration of MyPower VG2000-32S VoIP
gateway: baud rate 9600, 8 bit data, no parity check, 1 stop
bit, no flow control.
2. Check the identifier on the interface to avoid inserting
incorrectly to other interfaces.
3.3.2 Ethernet Cable Connection
Straight-through Ethernet cable model: C1212-1002. Connect
the Ethernet interface by the following steps:
Step 1: Insert the one end of the Ethernet cable to FE0 or FE1
Ethernet interface.
Step 2: Connect the other end of the Ethernet cable to the HUB,
switch, PC or other network devices.
Note
Check the identifier on the interface during connection to avoid
module or VG2000-32S VoIP gateway host damage by inserting
other interfaces. Check the host panel indicator state when the
system enters the normal work state. The LINK indicator on
indicates that the link is connected and indicator off indicates
that the link is not connected and check the line in this situation.
3.3.3 POTS(FXS) Cable Connection
Insert one end of the RJ11 cable to the corresponding interface
of the device and the other end to the telephone phone terminal.
