MyPower VG2000 V4 VoIP Gateway Installation Manual
Page
43 / 72
2. Check the identifier on the interface to avoid inserting
incorrectly to other interfaces.
4.3.2 Ethernet Cable Connection
Straight-through Ethernet cable model: C1212-1002. Connect
the Ethernet interface by the following steps:
Step 1: Insert the one end of the Ethernet cable to FE0, FE1 or
FE2 Ethernet interface.
Step 2: Connect the other end of the Ethernet cable to the HUB,
switch, PC or other network devices.
Note
Check the identifier on the interface during connection to avoid
module or VG2000-32 VoIP gateway host damage by inserting
other interfaces. Check the host panel indicator state when the
system enters the normal work state. The LINK indicator on
indicates that the link is connected and indicator off indicates
that the link is not connected and check the line in this
situation.
4.3.3 Module Cable Connection
The VoIP gateway module and its cable are described as shown
in Table 4-1:
Table 4-1 MyPower VG2000 module and its cable
S
N.
VG2000
Compon
Product
Descripti
Produ
ct
Cable
Remar
ks
