MyPower VG2000 V4 VoIP Gateway Installation Manual
Page
16 / 72
Figure 2-5 Diagram of installing MyPower VG2000-16 VoIP
gateway to the cabinet
1. Wear the glove and ESD wrist strap and connect the ESD
wrist strap to the ground reliably.
2. Place the device on a fixed platform horizontally. Aim the
supporting bracket installation hole to the corresponding
hole on the device side and fix the supporting brackets to the
both two sides of the device using screws.
3. The front side of the device faces the handler. Use hands to
stably hold the device and keep the device horizontally.
Carefully place the device on the supporting bracket or
supporting board from the front side of the cabinet. Please
avoid the device and cabinet upright post collision during
placing.
4. Push the device using two hands and keep the supporting
bracket of the device closely attached to the cabinet upright
post surface.
5. Use a fixed screw to install the device on the upright post of
the device.
6. Check whether the device is installed tightly and straightly.
7. Check the space between the installed devices. Choose an
appropriate blank panel (standard cabinet accessory) and
