MAINE ENERGY SYSTEMS AutoPellet Air TOUCH 17, Руководство по установке

Страница: 58 / 76

58 Malfunction report
13.11 Motor extraction auger 1 - RA (Fault 5026)
Display: [5026] Motor ext auger1
Description:
Storage room auger 1 motor defect – Output RA
Cause and Remedy: Motor unplugged
►
Plug in motor, check cable connections
motor is jammed
►
Remove pellets and dust from auger and
make sure auger rotates freely
Motor defect
►
Replace motor
Thermic contact triggered
►
Let motor cool down
Motor not running
►
Check thermic contact
13.12 Hopper motor (Fault 5028)
Display: [5028] Hopper motor
Description: Hopper suction fan fault. Output ZW.
Cause and Remedy: Motor unplugged
►
Plug in motor, check cable connections
Motor defect
►
Replace motor
13.13 Emergeny OFF/ Safety temperature (Fault 5032, 5033)
Display:
[5032] Emergeny OFF – NOT AUS
Description: Emergency OFF has been actuated – Input NOT-AUS
Cause and Remedy: Emergency OFF
unplugged
►
Connect up Emergency OFF and check cab-
le connections
Emergency OFF button
has been pressed
►
Reset Emergency OFF switch
Emergency OFF defect
►
Replace Emergency OFF switch
Display: [5033] Safety temperature - STB
Description: Safety temperature limiter has tripped – Input STB
Cause and Remedy: Safety temperature limiter
unplugged
►
Connect up safety temperature limiter and
check cable connections
Safety temperature limiter
has tripped
►
Let Furnace cool down and reset safety
temperature limiter
Safety temperature limiter
defect
►
Replace safety temperature limiter
A 230V Output is defect
►
Check 230V Outputs
13.14 Temperature Combustion chamber sensor/Flue gas sensor (Fault 5034, 5036)
Display:
[5034] PE Ignition fault / Pellets available?
Description:
Minimum temperature Combustion chamber sensor/Flue gas sensor not rea-
ched durring the ignition phase
Cause and Remedy: No pellets available
►
Fill up with pellets
Ignition electrode defect
► Check ignition electrode (approx. 200 Ω ) re-
place if required
Ignition nozzle blocked
►
Clean burner plate and ignition tube
PE 603 USA_FA 1.0