MAINE ENERGY SYSTEMS AutoPellet Air TOUCH 17, Руководство по установке

Страница: 49 / 76

Starting up for the first time
49
110 0
Starting up for the first time
After bringing in the Furnace, connecting up the hydronics and power supply, the unit can be started up for
the first time.
A Aiirr ttiig gh htt p prro op pe errtty y o off c co om mb bu ussttiio on n c ch ha am mb be err
To ensure correct combustion and overall operation, all
fittings to the combustion chamber must be correctly
assembled to be completely air-tight.
Note:
The Furnace may only be commissioned (first start-up) by an authorized installer.
Before starting up the pellet Furnace, the following settings must be made in the sequence specified below:
1. Adjust power rating
2. Settings in the Furnace control unit
3. Output test - test all motors
4. Start the pellet Furnace
Use the checklist enclosed to document the start-up procedure.
P Prro op pe errtty y d da am ma ag ge e
The allowable limits of temperature for the controller on
the furnace are 40° F to 122° F. It is therefore necessary
that the furnace room be no hotter than 90° F to avoid
damage to the controller!
Installation Manual AutoPellet Air Furnace 17 — 28