3 - Command Set
DynaPro Mini| PIN Encryption Device | Programmer’s Manual (Commands)
Page 39 of 128 (
D99875629-43
)
Bit
7
6
5
4
3
2
1
0
Byte 2
Device Control 2 (default value = 0x00)
Bit 0 Allow Charging in iPod Accessory Protocol (iAP) mode (30-pin Only)
Configure charging mode
0 = Disable (default)
1 = Enable
Bit 1 MAC checking control for inbound online response (EMV Only)
Configure MAC requirement on inbound online response for
0 = Enable (default)
1 = Disable
Bit 2 Fin ICC Card Type Reporting:
Configure FiICC Card type reporting
0 = Enable (default)
1 = Disable
Bit 3 ARQC and Batch Data Output Format(Protected):
0 = DynaPro Format (default)
1 = Reserved For Future Use
Byte 3
Mask Configuration (default value = 0xC0, all enabled except MS2.0)
ISO Mask
0 = Disable
1 = Enable
Check Digit
0 = Disable
1 = Enable
MS2.0 Enable
00 = MS2.0 Disabled
MS2.0 Only:
10 = MS2.0 Enabled
MS2.0 Only:
Track 2 Data
MS2.0 Only:
Track 1 Data
Error
Blank
Error
Blank
Byte 4
MSR Card Configuration (default value = 0xD5, all enabled)
AAMVA
Card
0 = Disable
1 = Enable
Non-finance
card option
Track 3 Data
00 = Disabled
01 = Enabled
11 = Required
Track 2 Data
00 = Disabled
01 = Enabled
11 = Required
Track 1 Data
00 = Disabled
01 = Enabled
11 = Required
Byte 5
Mask Character (factory setting is 0x30 representing ASCII ‘0’)
Byte 6
Leading length to leave unmasked
In SRED, maximum length = 6
MS2.0 Only: When the device is configured to use
MagneSafe MS2.0 format, values greater than 8 are
interpreted as 8; values less than 5 are interpreted as 5
Trailing length to leave unmasked
In SRED, maximum length = 4
Ignored in MS2.0 format
Byte 7
EMV L2 ICS Configuration (Default = 0x01)
Note: This setting is ignored when EMV Mode is disabled.