3 - Command Set
DynaPro Mini| PIN Encryption Device | Programmer’s Manual (Commands)
Page 35 of 128 (
D99875629-43
)
Bit
7
6
5
4
3
2
1
0
Byte 4
Tone Pattern:
0 = No start beep, one timeout beep
1 = One start beep, one timeout beep
2 = Two start beeps, one timeout beep
100 = No start beep, no timeout beep
101 = One start beep, no timeout beep
102 = Two start beep, no timeout beep
3.4.7
Command 0x07 - Display Message
This command directs the device to display a predefined message for a specified time. Examples are
shown below.
Figure 3-5 - DynaPro Mini Messages
If an error occurs, the device will terminate the command and report the error in ACKSTS of
. For a full list of error codes, see
Appendix C Status and Message Table, Table
If no error occurs, when the command completes (message displayed, cardholder or operator cancelled, or
timeout), the device will do the following:
1)
Clear the display
2)
Return to the idle state
3)
Report 0x27 - Display Message Done Report
Table 3-7 - Usage Table for Command 0x07
Bit
7
6
5
4
3
2
1
0
Byte 0
0x07
Byte 1
Wait Time in seconds, (1 - 255; 0 = infinite wait time)