53
5.16.6 Installation of cross perforation bar (optional)
In the figure 1, when pull out the slide-in tool, please push the tool’s locker to
right (red arrow), then user can pull out the inside tool. Next, the perforation
bar (or crease bar) can be push inside. The tool’s locker will automatic lock
the bar. Please make sure the bat is fully pushed inside the machine,
otherwise, the machine will show error message.
Note: For perforation bar, please make sure the white plastic paper deflector
faces the feeding table. Then, the crease depth setting in paper data setting
screen might need to change, depends on situation.
On the other hand, in the outfeed area, there are several outfeed lags wheels
(shown below diagram). They avoid outfeed skewing.
However, the wheels will pressure the perforation line and make a mark on
the paper, which is shown in following photos. There are about 6 marks on
each perforation. The red rectangle shows the first mark on each line. Those
effects are unavoidable.
①
②
