17
Paper deflector is about 1mm away from the skewing adjustment wall. The
paper deflector avoid paper crash and flapping. For thin paper, please use
long deflector. For thick paper, please use short deflector.
Note:
1. (a) When using thick paper (250gsm to 350gsm), remove the two long
paper deflector. Only use the short deflector and locate it near the pillar paper
guide about 1mm.
(b)When using thin paper (157gsm to 200gsm), remove the short deflector
and use two long deflector.
That can avoid skewing product because of paper’s side flapping.
2. Paper deflector B is for avoiding paper flapping during infeed. Then the
paper can feed along the skewing adjustment wall smoothly. It avoids to make
the skewing product which caused by the unstable infeed.
3. The function of paper deflector A is same as paper deflector B. They are
suggested to be used during every jobs.
4. (a) When pillar paper guide is pushed load of paper (to non-operation
side) too much, paper cannot be fed to the infeed rollers. It will cause machine
show paper jam error message.
(b) When pillar paper guide is away load of paper, paper cannot be fed
stable. It will cause skewing product.
(c) When blowing air is too strong, it will also make skewing product. The
blow air power need to be adjusted in a suitable level, which can blow the
paper but the paper will not fly. For thin paper, the blowing power need to be
low.
Short paper deflector
Paper deflector B
Paper deflector A
Long paper deflector
Pillar paper guide
