i
Warnings and Cautions
This Section provides warnings and cautions pertinent to this product, that if not
heeded, may result in personal injury, fatality, or equipment damage.
Magnetek
is not responsible for consequences of ignoring these instructions.
Magnetek
manufactures component parts that can be used in a wide variety of applications. The selection and application
of
Magnetek
products remain the responsibility of the equipment designer or end user.
Magnetek
accepts no responsibility
for the way its products are incorporated into the final system design. Under no circumstances should any
Magnetek
product be incorporated into any product or design as the exclusive or sole safety control. Without exception, all controls
should be designed to detect faults dynamically and fail safely under all circumstances. All products designed to
incorporate a component part manufactured by
Magnetek
must be supplied to the end user with appropriate warnings and
instructions as to that part’s safe use and operation. Any warnings provided by
Magnetek
must be promptly provided to the
end user.
Magnetek
offers an express warranty only as to the quality of its products in conforming to standards and
specifications published in the
Magnetek
manual. NO OTHER WARRANTY, EXPRESS OR IMPLIED, IS OFFERED.
Magnetek
assumes no liability for any personal injury, property damage, losses, or claims arising from misapplication of its
products.
•
Read and understand this manual before installing, operating, or servicing this Drive. All warnings, cautions, and
instructions must be followed. All activity must be performed by qualified personnel. The Drive must be installed according
to this manual and local codes.
•
Do not connect or disconnect wiring while the power is on. Do not remove covers or touch circuit boards while the power is
on. Do not remove or insert the digital operator while power is on.
•
Before servicing, disconnect all power to the equipment. The internal capacitor remains charged even after the power supply
is turned off. The charge indicator LED will extinguish when the DC bus voltage is below 50Vdc. To prevent electric shock,
wait at least five minutes after all indicators are OFF and measure DC bus voltage level to confirm safe level.
•
Do not perform a withstand voltage test on any part of the unit. This equipment uses sensitive devices and may be damaged
by high voltage.
•
The Drive is suitable for circuits capable of delivering not more than 100,000 RMS symmetrical Amperes,
1000VAC
. This product requires installation of Branch Circuit
Protection (BCP) as defined in NFPA 70 of the National
Electrical Code, Article 430, Section IV, Paragraph 430.52. Failure
to comply may result in injury to personnel from fire.
Refer to Appendix E for further details.
•
Do not connect unapproved LC or RC interference suppression filters, capacitors, or overvoltage protection devices to the
output of the Drive. These devices may generate peak currents that exceed Drive specifications.
WARNING
WARNING
WARNING
