Connection Diagram
2-
3
IMPORTANT
1. Control circuit terminals are arranged as shown below.
2.
The output current capacity of the +V terminal is 20 mA.
3.
Main circuit terminals are indicated with double circles and control circuit terminals are indicated with single
circles.
4.
The wiring for a motor with a cooling fan is not required for self-cooling motors.
5.
PG circuit wiring (i.e., wiring to the PG-X2 Card) is not required for open-loop vector control
or volts/Hz
control.
6.
Sequence input signals S1 to S12 are labeled for sequence connections (0 V common and sinking mode)
for no-voltage contacts or NPN transistors. These are the default settings.
For PNP transistor sequence connections (+24V common and sourcing mode) or to provide a 24-V exter-
nal power supply, refer to
.
7.
The master speed frequency reference can set to input either a voltage (terminal A1) or current (terminal
A2) by changing the setting of parameter H3-13. The default setting is for a voltage reference input.
8.
The multi-function analog output is a dedicated meter output for an analog frequency meter, ammeter, volt-
meter, wattmeter, etc. Do not use this output for feedback control or for any other control purpose.
S12
S11
M2
MC
MB
M1
MA
M3
M5
M4
M6
IG
RP
S
AM
AC
S+
AC
MP
R
FM
A3
R+
S8
V
C4
S7
AC
P4
S6
+V
C3
S5
A2
P3
S4
A1
S3
SP
S1
SN
S9
S2
SC
S10
E(G)
E(G)
Wires are run from the
control board
terminal blocks to TB9 for ease
and
convenience
of connecting. The landing points for the wires are
in the below diagram.