TER Ceska
Flex EX 4, Flex EX 6
Instruction manual
•
Use only approved chargers for the appropriate battery pack.
•
Do not attempt to use a battery that is leaking, swollen or corroded.
•
Charger units are not intended for outdoor use. Use only indoors.
3.9. BATTERY DISPOSAL
Before disposing of batteries consult local and governmental regulatory requirements for proper disposal procedure.
3.10. SPECIFIC SYSTEM WARNINGS
Below are some specific operating safety tips that should be strictly followed when operating a Flex EX systems:
1. Always check the transmitter handset for any damage that might inhibit proper crane operation prior to crane
operation.
2. Check the Status LED on the transmitter for any signs of low battery power (refer to page 21).
3. Check the Status LED on the transmitter for any signs of irregularities (refer to page 21).
4. The crane limit switches should be checked prior to crane operation or at the beginning of each shift. When checking
limit switches the hoist should be centered over an area free of personnel and equipment.
5. If the power to the crane is removed, the operator should turn off the transmitter power immediately until the
power to the crane is restored.
6. If the crane fails to respond properly to operator’s command the operator should stop operation, turn the
transmitter power off, and then report the condition to their supervisor.
7. The transmitter power should be turned off after each use. If the transmitter handset is not in use always turn the
power off and store it in a safe or designated location. Never leave the transmitter handset unattended in the
working area.
8. Make sure the system is not set to the same channel as any other Flex EX systems in use within a distance of 300
meters.
9. Never operate equipment with two transmitter handsets at the same time unless they are programmed to do so.
Page 7 of 27
December 2015
