TER Ceska
Flex EX 4, Flex EX 6
Instruction manual
10. STATUS LIGHT INDICATORS & WARNINGS
10.1. Transmitter STATUS Light Indication
Type
Display Type
Indication
1
Constant red
Voltage goes below 1.9V at initial power on –
transmitter power shuts off.
Voltage goes below 1.8V during operation –
transmitter power shuts off. Turn the power
off to disengage the receiver main.
2
1 red blink followed by a 2 second pause
Voltage goes below 1.85V during operation –
change batteries immediately.
3
2 red blinks followed by a 2 second pause The push button is defective after turning on
the transmitter power.
4
No light displayed
When a defective push button condition
occurs (2 red blinks, type 3 above), find out
which push button is defective by pressing all
the push buttons on the transmitter one at a
time. If the push button is in good working
order, the LED will not light up when pressed.
If the push button is defective the LED will
continue to display 2 red blinks when
pressed.
5
3 red blinks followed by a 2 second pause EEPROM error.
6
4 red blinks followed by a 2 second pause Transmitting error.
7
Constant green for up to 2 seconds
Transmitter power on with no faults detected
(prior to initiating the START function).
8
Blinking green
Transmitter in operation.
9
Orange
Transmitter on standby.
Page 21 of 27
December 2015
